How to construct the floor paint?

1. Foundation treatment: grind the ground with a grinder and clean and vacuum it.

2. Scraping epoxy primer: Scraping epoxy penetration sealing primer to increase the adhesion of paint layer.

3. Batch scraping putty layer: Batch scraping putty layer twice to better fill the ground.

4. Roll-coating topcoat: After the materials are stirred evenly, roll-coating tung oil on the wear-resistant topcoat twice.

5. It can be used normally after one week of maintenance.

A certain amount of volatile organic compounds (VOC) will be emitted during construction and curing, but the cost is relatively low; Solvent-free epoxy floor coating conforms to the concept of environmental protection and has no emission of volatile organic compounds. It is widely used for surface treatment of modern industrial floors.

Extended data:

Matters needing attention

1. Anyone who enters the workshop needs to change shoes (to avoid bringing mud and sand into the workshop and scratching the ground);

2. All hardware must be wrapped in soft plastic or rubber to avoid scratching the ground during use;

3. When dragging the tray, the tray must be completely lifted off the ground. When turning, pay special attention to the tray angle not to scratch the ground;

4. When cleaning the ground, you need to use a soft mop or a wet and dry vacuum cleaner, which can be cleaned with water or detergent, but pay attention to the slippery ground;

5. If it is worn or scratched due to long-term use, a small area can be repaired locally. If the area is large, it is recommended to roll or smooth it again.

Baidu encyclopedia-epoxy primer

Baidu encyclopedia-floor paint