How to design bookmarks?

1, making stickers: make stickers in quicksand, stick transparent glue for waterproofing, and then reinforce them with straight clips.

2. Making a bag: Prepare a small bag filled with quicksand, wrap a piece of paper on the side of the bag, and seal the three sides with a straight clip. The heating time can be longer, and it will be a transparent packet after cooling.

3. Bagging and sealing: add glue, sequins, sequins and small patterns cut out before into the small bag, stir well, and seal the last edge in the same way to make it slightly wider.

The second method is as follows:

The first step: paper-cutting, cutting the paper into strips or shapes you like (you can also draw it first and then cut it).

Step 2: Spread water, make a preliminary spot dyeing, soak the brush with water, and gently smear it on the bookmark surface (be careful not to use too much water and grasp the degree). When the white paper is still wet, use a brush to color the green pigment and smear the embryonic form of the tree.

Step 3: Shading: Absorb the pigments in some areas with paper, distinguish the shades of colors, and display different parts of the tree by clicking, pressing and wiping with a brush.

Step 4: Draw the trunk and branches. Draw trunks and branches in dark ochre. Please note that some trunks are covered and cannot be drawn to show layering.

Step 5: Tie a ribbon on the bookmark, which can be done without sketching.