Common faults of obstacle radar

1. It needs to be analyzed from two levels to identify that the car is not working after intelligent braking; Yes, see whether the front-end license plate recognition system works normally and whether everything recognizes the car normally; If all the recognition is normal, the license plate of the lunar rover will be incorrect because of the light source or angle of view, which will also lead to the failure of the telephone pole. The license plate can be modified and released through the charge management host.

If the lane is too wide, control the lane within 4 meters or increase the isolation guardrail. It is also possible that the license plate recognition system has been displaced and blocked by objects, and the recognition area has changed, which will affect the recognition effect and need technical personnel to deal with it. The cause of equipment failure is also possible. Check whether there are enough monitoring screens on the charging computer. If there is no monitoring screen, it means that the license plate recognition system is not connected or there is equipment failure.

2. The vehicle cannot automatically lower the brake after passing through the rear brake; This situation is more or less due to the linkage system of highway brakes. First, it can be seen that the ground circuit is broken enough, and problems in the ground circuit will also cause the brake to fall off. Secondly, if the car inspector crashes or breaks down, he will fall off the pole. The control panel and motor of the road brake are also faulty, which will also lead to rod falling.

3. The brakes are abnormal and not in place; The lifting rod is not in place, etc. This will not happen in the new generation of digital limits. A similar situation will happen in the previous mechanical limit or photoelectric limit.

The main reason is that the length ratio of the door rod has changed since the installation, and the imbalance of the tension spring ratio will lead to the fluctuation of the door rod, and it will not fall and rise in place. There are also cases where billboards are added to the door rods, which will lead to imbalance between the motor and the tension spring counterweight, and similar situations will occur; Or the foundation is loose, and the expansion bolt of the fixed equipment is loose, which will cause brake jitter.