Why does the float rise to the top during fishing?

Because the bait is lying on the bottom of the water, when the crucian carp eats the bait, it inhales it with its head downward and its tail upward. After the entrance, the crucian carp straightens its posture and raises its head, and the corresponding float rises to the top. . Fishing steps:

Roughly find the bottom:

No sub-lines are hung, and heavy lead is hung on the lead skin base. The weight of the lead skin is greater than the buoyancy of the float. The float is completely submerged in the water and gradually pulled up. Float until it is visible. The top space bean is located next to the second space bean. Complete the positioning. Remember not to touch the top space bean until the end of this fishing.

Adjust the mesh:

Pull the float down 25 cm. At this time, the float should be completely submerged in the water. Gradually cut the lead skin until the required mesh number is exposed.

3. Basic principles for mesh adjustment and fishing mesh setting:

7-mesh soft-tail floating bait: adjust 4-5 to catch 2, 7-mesh soft-tail floating bait: adjust 3-4 to catch 2, hard thin tail rub bait: adjust 7-9 mesh, catch 2-3 mesh, hard thin tail pull bait: adjust 5-7 mesh, catch 2-3 mesh, catch high mesh, catch blunt; The eyes are low, fishing for spirits. Fine-tune the above adjustments according to the weather, season, hook weight, bait specific gravity and bait ball size.

Find the bottom accurately:

Hang up the sub-line, move the float, and adjust the distance between the position of the float seat and the position of the positioned upper space bean to be approximately equal to the length of the sub-line. Lower the hook, rub the bait, and hang a large bait ball to find the bottom (also to make a nest), so that the float is 2 mesh above the water surface, and continue to pull the float up for 2 cm. If the float shows more than 3 mesh, it means it has passed the bottom, and the float is pulled back down. 2 cm, this action is called reverse bottom search, then hang a bait ball of normal fishing size and throw the rod into the water, fine-tune the float until the fishing mesh is about 2 mesh, and conduct trial fishing.

Trial fishing adjustment process:

(1) There is a mouth but no fish: fishing is too good, pull up the float 2CM (can be pulled up continuously within 5 times), and catch fish continuously on the upper lip More than 2 times means you have found the right answer. (2) The fish caught is on the side of the mouth or on the lower jaw. This means the fishing is too blunt. Pull the float up 1 cm each time. If the fish hits the upper lip more than twice, the right mouth is found. (3) There is no mouth when fishing at the bottom: Pull down the float 15 centimeters each time to find the water layer where the fish is. This falls into the category of fishing off the bottom - fishing on the float - fishing for one mark of depth

Lead fishing Method:

1. Scope of application: Used when fishing in flowing water or small miscellaneous fish. The fishing method is similar to traditional fishing.

2. Steps of running lead and drift adjustment

(1) In the hookless state, heavy lead is used to find the bottom.

(2) Pull the float down 20CM and cut the lead skin to level with the water.

(3) Open the space bean on the lead seat by 3-5 cm.

(4) Hook, pull up the float until 2-6 meshes are exposed, and you can fish. If the water flow is fast, many meshes will be exposed

. Precautions for lead fishing method

p>

(1) In a flowing water environment, try to choose a large float with strong positioning ability, such as the No. 3 float of Daolang A018.

(2) The sub-line should be kept as short as possible and within 10 centimeters. Because lead fishing is extremely blunt, short sub-lines can amplify the signal.

(3) Both the upward and downward movements should be used to catch fish.

(4) The bait can be appropriately sticky.

If the drift phase only rises slowly but does not pause, or only slowly descends to the negative phase after rising, you can adjust the drift phase by pulling down until there is a slow rise and then a slight pause. .

2. The drift phase only rises slowly but does not drop. Adjusting the fishing eye by pulling down the float is ineffective. This is mostly related to the bait state and size. You can adjust the bait state and bait application method in time before asking for a mouth. , explore.