How to draw yellow and black paint markings?

The drawing strategy of yellow and black paint marks is as follows:

First, clean the surface of the isolation pier. When cleaning, you can use a brush or towel to clean up the dust, oil stains and water stains on the surface of the isolation pier, remove the big scars, fill the holes with putty, and polish them smoothly for later use. In order to be beautiful, the surface of the isolation pier needs to be evenly divided into several equal parts, or three or four parts.

According to the sequence of black and yellow intervals, paper tape with a width greater than 5CM is used as the dividing line. Just spray paint directly, and the paint should be reflective paint, a cement anti-collision pier. After spraying one color, stick a paper tape as the dividing line, and then spray another color of paint. In order to enhance the effect, it is best to spray each color of paint twice. After spraying two colors of paint and cleaning the tape, it is finished.

Attention: Pay attention to safety during the whole operation. Including traffic safety protection and paint injury protection.

Related categories:

1, with a line width of 60mm: in principle, it is used for positioning lines of articles.

2. Line width 80mm: In principle, it is used for equipment area lines.

3. Line width 120mm: in principle, it is used for the main channel line.

4. Line width 60mm: the internal dividing line and allowable traffic line of the large operation area (which can be combined with the actual situation).

5. Line width 60mm: the dividing line of the defective product placement area (draw a solid red line when the fourth floor is in contact with three walls).