Steps for property cleaning water tank

Property water tank cleaning steps and procedures:

1. After determining the cleaning time, a notice should be given to stop the water, informing the time required for cleaning and the time of the water stop, so as to facilitate users to store water. Prepare.

2. You should understand the operation of the water supply system, master the number, material and water storage tonnage of water tanks, determine the power connection parts and the manpower, material resources and equipment required for cleaning, and make all preparations accordingly , notify to stop water supply and discharge.

3. After entering the site, connect the power supply, check whether there is power or leakage, whether there are any hidden dangers and minor safety issues; then place the water pump to pump water, drain water, and observe the drainage situation at any time.

4. When the remaining water in the pool is 12cm-20cm, cleaning personnel should wear cleaning overalls and rain boots to enter the pool. It is strictly forbidden to enter the pool barefoot or wearing your own clothes. Scrub the bottom and bottom of the pool 3 times from the walls around the top of the pool (especially where there are crevices between the pool walls) to thoroughly remove spider webs, sediment, and water stains, and withdraw the cleaning personnel. Rinse twice with clean water in the above order and drain away the dirty water.

Water tank cleaning and disinfection process:

1. After cleaning, withdraw the water pump, disconnect the power supply, and prepare for disinfection.

2. Preparation of disinfectant: According to the water storage capacity of the pool, dissolve the water in the container at a ratio of 0.05 to 0.1%, and put the can in a compression sprayer. The disinfectant wears protective clothing and Wear a mask and gloves, enter the pool and perform spray disinfection from the top, around the walls, to the bottom of the pool, and then exit the pool (you cannot set foot in disinfected areas).

3. After covering the inlet and outlet holes for 30 minutes, put water into the pool and clean away the remaining drugs.

4. Open the water inlet valve to deliver water and disinfect the drinking water.

5. Clean the area around the pool (box).