Satellite pan can't receive the signal. What's going on? How to adjust it?

The satellite cooker can't receive the signal because the position is wrong or the signal wire is not connected properly.

Adjustment method:

1, press the F3 key of the remote control, which is the star adjustment key.

2, squatting behind the small pot, first slowly turn the chassis to maximize the signal quality.

3. Adjust the elevation to maximize the signal quality.

4. If the signal quality keeps going up; It is necessary to check whether the polarization direction of the tuner is correct and ensure that the 0 scale is directly above; Ensure that the vertical rear elevation angle of the cauldron is kept at about 15 degrees; Make sure that the horizontal direction is kept in the general direction of about 43 degrees west of due south.

5. The geographical location is different, so the small pot should be adjusted slowly and carefully.

Extended data:

Solution to poor signal quality of satellite antenna;

The signal quality of the satellite antenna is zero, but it is not aimed at the satellite, so there is no signal quality.

The existence of signal strength only shows that the equipment is good. Only when the% value of "Signal Quality" appears and reaches a certain value can it be viewed. Star adjustment is not only monotonous in the left and right directions, but also monotonous in the up and down elevation angles. Gradually adjust the satellite antenna, that is, the azimuth angle, elevation angle and polarization angle of the satellite to be received.

The settings in the machine are also important. One mistake can't be adjusted. It may even damage the machine. I really can't find a professional to debug.

Connect all signal lines and turn on the TV and receiver. At this time, you will see the working picture of the satellite receiver, and the machine will automatically scan the program. If not, it will prompt that the received program is zero.

Press the information key at this time, and you will see two stop signs, one is signal strength (about above 40%) and the other is signal quality (after aiming at the satellite, the indicator bar will become longer, and some will turn green, indicating that the program is locked and the number is above 30%). At this time, aim the antenna at the southwest-west position and slowly move it up and down.

Look at the changes in signal quality and intensity during moving. If it suddenly becomes longer or flashes, then this position is the satellite position. Repeat adjustment at this position until the signal quality reaches the best.