380v remote wireless remote control switch

Installation and use of 380v intelligent remote control switch

Take three rows of switches as an example. Turn to the 0 position, connect the circuit point you want to connect at this position, and then turn to the 1 position to connect the point you want to connect. 2 position also operates in the same way.

The wireless remote controller consists of a remote control transmitter and a remote control receiver, and the remote control receivers are used in pairs. The remote controller sends an operation instruction, and the remote controller receives the operation instruction to control the relay (contactor) to act.

The contactor coil assumes that 2 1 13 is the remote control switching load, and the three-phase AC 526 1 contactor motor comprehensive protection 4 102 and remote control 1653 wiring diagrams. The wireless remote controller consists of a remote control transmitter and a remote control receiver used in pairs.

No hello, no, the 380V remote control switch needs to be connected to the power supply to be used normally. Even after the switch is closed, it cannot be switched.

Telephone control: you can remotely or turn off the electrical switch, insert the mobile phone card and turn on the power supply (380V\220V or 12V). You can access this controller by SMS anytime and anywhere, so as to operate household appliances, industrial motors and other electrical equipment, and achieve the purpose of remote control of electrical equipment by SMS.

The operation method of remote control switch and remote control code for 380v water pump is as follows: turn on the remote control host of water pump and turn on the power supply.

Can 380v remote control switch use no motor?

If the motor starter like this is said to be ineffective without power, press the remote control. Due to this situation, the internal clock battery cannot drive the relay.

The contactor coil is assumed to be a remote control switch load, a three-phase AC contactor motor comprehensive protector and a remote control wiring diagram. The wireless remote controller consists of a remote transmitter and a remote receiver used in pairs. The remote controller sends an operation command, and the remote controller receives the operation command to control the action of the relay (contactor).

In this case, the first thing to look at is the power of the motor. If it is two 5 kilowatts, it is impossible.

Can the 380v remote wireless remote controller connect the incoming power supply to the brake if there are too many outgoing lines?

1, you can push it directly, because you use high-power appliances or the line is short-circuited. If it is a line, the short circuit will be pushed up and it will trip. If it does not jump, it proves that the line is in good condition and can continue to be used. Turn off all switches and unplug all electrical plugs, including the basement and other careless places.

2. The red line is connected to the main contactor coil, the yellow line and the green line are connected to the "upper" and "lower" contactors, the green line and the blue line are connected to the "east" and "west" contactors, the gray line and the white line are connected to the "south" and "north" contactors, and the pink line is the standby line 2 1 13 without pipes.

3. Answer and communicate. There is also a direct connection. The maximum load of the relay is 30 kW.

4. Causes of air switch tripping: short circuit to ground at the load side of air switch, damage to air switch and misoperation. Air switch too small, overload trip. Solution: check the line insulation on the load side at the beginning of the air, and measure the line insulation with a multimeter resistance file.

5. The wireless remote controller consists of a remote transmitter and a remote receiver, and the remote receivers are used in pairs. The remote controller sends an operation instruction, and the remote controller receives the operation instruction to control the relay (contactor) to act.