Voice reminder of short message for driving in foggy days

This prompt tone is part of the subject three-way exam. There are two ways to do this:

1. Take the exam during the day, just slow down and take your time.

In the night exam, be careful not to use the high beam when you meet a car. Generally, you will turn off the high beam and use the low beam after starting, so when you meet a car, the light will remain the same and slow down.

After the meeting, the operation steps are as follows:

1. After observing the right rearview mirror to make sure it is safe, turn on the right turn signal for 3 seconds and change lanes to the right.

2. Turn off the right turn signal immediately after changing lanes, and observe the oncoming cars to ensure safe passing.

3. There are three opportunities to rush in the third exam, driving in a straight line, adding and subtracting gears and meeting cars. If driving in a straight line and increasing and decreasing gears have been speeded up, the passing car may not rush. If you don't drive in a straight line, you will rush to the fifth gear, 45 mph, and the top speed can't exceed 60 mph.

4. Rush to the fifth gear and quickly downshift to the second gear.

5. The above operations should be completed before the next project prompt, but not too early, so as not to affect the performance when the average speed of the whole process is less than 25.

6. If it is a night test, turn off the high beam, turn on the low beam and slow down. It is not recommended to meet the speed in the night test. When driving in a straight line, you must accelerate.

The specific scoring criteria are as follows:

1, if the turn signal is not turned before overtaking, 20 points will be deducted;

2, in front of the car, turn on the turn signal less than 3 seconds, 10;

3. On the road without central isolation facilities or center line, if you don't slow down and drive to the right, and don't keep a safe distance from other vehicles, pedestrians and non-motor vehicles, you will fail;

4. If you encounter car trouble, don't let it go and fail;

5. Poor judgment on the lateral safety distance, emergency steering to avoid failure from the opposite direction;

6. Failing to pass the train according to the voice instruction within the specified time and distance.

Subject three exam skills:

1. There is no street lamp when driving at night, and the lighting is not good. Correct operation: width indicator and high beam.

Please change the headlight into high beam. Correct operation: keep still when the high beam is turned on; When the low beam is turned on, switch to the high beam.

3. Meet non-motor vehicles on narrow roads at night. Correct operation: Turn on the low beam.

4. Meet a motor vehicle at night. Correct operation: Turn on the low beam.

5. Go through sharp bends and slopes at night. Correct operation: the far and near light flashes alternately twice.

6. Follow the car at close range in the same direction at night. Correct operation: Turn on the low beam.

7. Overtaking at night. Correct operation: the left turn signal and the far and near light alternate.

8. The road is broken at night, and the traffic is hard to move. Correct operation: turn off the headlight group and turn on the width indicator and warning light.

9. Pass the intersection without traffic lights at night. Correct operation: the far and near light flashes alternately twice.

10. Cross the arch bridge and crosswalk at night. Correct operation: the far and near light flashes alternately twice.

Driving in foggy weather. Correct operation: Turn on the width indicator, front and rear fog lights and warning lights.

12. Please turn off all the lights after the simulated night exam. Correct operation: Turn off all the lights.