How to install Anjubao visual intercom

Anjubao building intercom system is the access control and security system that many communities will choose. It can realize the functions of visual intercom, remote unlocking, monitoring the movement of entrances and exits, security setting, emergency call for help, receiving short messages and so on. Basically, every community will be equipped with it, but what is the installation process of Anjubao building intercom system? Will it be difficult to pretend? How to install Anjubao visual intercom? We can study together. Installation process of intercom system in Anjubao Building

1, installation method of management machine

(1) During installation, live operation is strictly prohibited, and wiring is far away from interference sources.

(2) After all wires are connected, they can only be electrified after repeated inspection.

(3) If the work is not normal and the cause of the failure is not found out, please contact the after-sales service department of Anjubao, and do not repair or replace the original one by yourself, which will cause greater losses.

2, the unit door crane installation method

(1) The video intercom host should be installed at the height of 150cm between the ground and the camera lens center.

(2) When installing the visual intercom host, the influence of camera lens backlight on video images should be fully considered, and direct sunlight on CCD should be avoided as far as possible.

3, visual intercom extension installation method

The video intercom extension shall be installed at the height of 150cm between the ground and the center of the screen.

4, access control installation method

Firstly, fix the installation hanging iron on the wall (or in the iron box) with screws, and finally clip the access controller correctly to complete the installation.

5, card reader installation method

First, pry the face frame (shell) of the card reader down. After the lead wire of the card reader body is correctly connected with the lead wire of the wall, fix the card reader body on box 86 with screws. Finally, buckle the face frame (shell) on the installed card reader body correctly to complete the installation.

How to install Anjubao visual intercom

1. First, it is necessary to install the equipment box of the video walkie-talkie in a position that meets the requirements, as far as possible from the ground 1.4m, and fix it with expansion bolts to keep the box body of the equipment box horizontal and not inclined.

2. After installing the equipment box, you need to install the equipment. You need to install the power box first. The power box can be installed on the wall inside the security door, not too far away from the electric lock, and it can be kept at about 8 meters.

3. After the installation is completed, you need to install the host at the door. The main engine should be installed on the wall outside the security door as far as possible, and it needs to be 1.5 meters away from the ground. After installation, the indoor unit needs to be installed, and it also needs to be about 1.5 meters away from the ground.

4. After all the equipment is installed, you need to connect the equipment. When connecting, it is necessary to connect the corresponding wires to the corresponding terminals. Once fully connected, you can use visual dialogue.

Matters needing attention in using visual interphone

1. Every time you turn on your mobile phone, you need to check whether the channel you are using is correct. If it is not correct, it is probably impossible to turn on the walkie-talkie.

2. When making a phone call, the walkie-talkie should be in a vertical state, and the microphone is about 3 cm to 5 cm away from the speaker.

3. The walkie-talkie needs to be charged after a period of use, and it is best to charge it for more than 8 hours at 1 time, otherwise it is likely to affect the service life and charging efficiency of the battery in the future.

4. After the walkie-talkie is used for a period of time, the buttons and casing on it are easy to get dirty, so it is necessary to remove the control knob on it regularly and use neutral detergent to clean it, so as to keep it clean and tidy, and at the same time, it will not affect the service life of the walkie-talkie.