IPhone6 plus glass film, how to paste the whole body film?

Iphone6 uses 2.5D curved screen glass, and ordinary film cannot completely cover the screen of iphone6. It is recommended to buy a film specially designed for 2.5D glass.

1. Wipe the screen with a cloth (or soft fiber cloth or glasses cloth) to thoroughly clean the screen of the mobile phone. It is best to wipe the screen indoors in a windless and clean environment to reduce the influence of dust on the film.

2. Take out the protective film from the package. Do not tear off the release film and put it directly on the screen of the mobile phone.

3. Tear off a part of ① release film, observe the label on the protective film, tear off a part of release film marked with "①", and pay attention to avoid fingers touching the adsorption layer of the protective film. Each protective film product is divided into three layers, of which ① and ② are release films for protecting the protective film in the middle.

4. Stick the protective film on the screen of the mobile phone slowly, aim the adsorption layer of the protective film at the corner of the screen, make sure the position is aligned, and then stick it carefully. When pasting, tear off the No.① release film. If bubbles appear during pasting, pull the film back and paste it again. After confirming that the position of the adhesive film is completely correct, completely tear off the No.① release film. After the whole protective film is attached to the screen, if bubbles are found, you can scrape the screen with a bank card to exhaust the air.

5. Finally, tear the release film ② completely.