How to clean headphones

Material preparation: alcohol, paper towels and cotton swabs.

Specific steps:

1. Step 1: Dip a cotton swab in an appropriate amount of alcohol, as shown in the following figure:

2. Step 2: Wipe the earphone gently with a cotton ball (the earphone can easily hide dirt, and alcohol can decompose the dirt and play a bactericidal role), as shown below:

3. Step 3: Pour a proper amount of alcohol on the paper towel, as shown in the following figure:

4. Step 4: Wipe the earphone cord from top to bottom with a paper towel, as shown in the following figure:

5. Step 5: The earphone cable is dirty, which means it has been cleaned, as shown below:

Use and maintenance of headphones:

1, it is best not to wear headphones when sleeping. It is absolutely impossible for ordinary people to stay still all night. After a long time, the headphone cable is either wrapped around the neck or twisted together like a twist, and some big headphones are even crushed.

2. Wipe off the sweat on the earphone line after using the earphone. These things secreted by the human body, which contain grease or something, are invisible killers of wires, such as e2c at the bend of the ear. After a long time, the wire will age and eventually lead to cracks and fractures.

It is best not to smoke when using headphones. In addition, soot will enter the earphone shell and stick to the diaphragm. After a long time, the sound will be wrong.

Please turn down the volume before use. If the volume of your output device is too loud, it will not only shock your ears, but also the membrane folds. In the worst case, the voice coil of the earphone is burnt out.

5, headphones away from strong magnetic. The magnetism of the unit magnet will decrease, and the sensitivity will decrease with time!

6, headphones away from moisture. The gasket in the earphone unit will rust, the resistance will increase, and your earphone will be biased.

7. Plug part. Some friends like to put mp3 or something in their trouser pockets. The outlet part of the plug is easy to fold and will be disconnected after a long time.

8. Do not disassemble. If you are too curious, just open it. Some headphones are difficult to disassemble. Mx500 can't be opened without special methods. Even if you open it 80%, it will be broken. If you open the small 2, the shell may be damaged or the sound may be deviated. 888, 808 and so on are ok, relatively easy to handle.

9. It is best not to use it outdoors in winter. It's very cold in winter, and the wires are hard and brittle. Excessive bending can easily break wires. Do not heat the earphone cable at this time, because high temperature will accelerate the aging of the cable.

10, away from chemicals. The paint on the earphone shell is very soluble in organic chemicals, so it doesn't look good when spent.